In the article is offered a combinatory approach for determination of information possibility of individual messages of discrete sources as quantity of information in them when taken into account recurrent alphabetic symbols and structural uniformity allowing to estimate and to optimize information possibilities of the used messages. 

This paper considers the dynamics of the abscissa and ordinate points in the far zone meridian six degree conformal Gauss-Kruger projection. Performed calculations and graphical representation of the classic formulas of conformal projection. 

Issues of the improvement of existing and development of new waste-free, material-saving production processes, in particular processes that provide for the production of workpieces with minimum allowance for subsequent mechanical processing while reducing consumption of scarce materials. 

A design of mechanical heat source, allows direct conversion of mechanical energy of the wind flow into thermal energy due to friction forces in a highly viscous fluid. Obtained theoretical dependence for calculating the heat generated by converting mechanical energy into heat. For laminar flow of a highly viscous, fluid in the gap between the stationary and rotating disk heat source. Based on experimental studies to determine the average thickness of the boundary layer between the rotating and fixed disks. The dependences to identify key structural dimensions of mechanical heat sources for heating systems. 

Early diagnosis of cancer is the most important measure in the struggle for the life of patient. In the work is proposed a new method and technical means for early detection in oncology, based on biological object presentation in the system with the time-variable parameters (STVP). 

Methods of computing and mathematical modeling are all widely used in the study of various heat exchange processes that provide the ability to study the dynamics of the processes, as well as to conduct a reasonable search for the optimal technological parameters of heat treatment.

This work is devoted to the identification of correlations among the factors that have the greatest effect on the rate of heating of the product at hightemperature heat sterilization in a stream of hot air, which are chosen as the temperature difference (between the most and least warming up points) and speed cans during heat sterilization.

As a result of the experimental data warming of the central and peripheral layers compote of apples in a 3 liter pot at high-temperature heat treatment in a stream of hot air obtained by the regression equation in the form of a seconddegree polynomial, taking into account the effects of pair interaction of these parameters. 

The article considers the stages of artistic analysis of masculine humeral service widespread on the territory of Daghestan in the nineteenth and early twentieth centuries. For example Circassian presents illustrative material: photos, technical drawing, scan cut. The results of the artistic design of the analysis are shown in table form and in the quality of the chart. The elements identified male costume can be used in design designing modern service. 

The article presents the results of studies of various options for technology planning and prospects for its development through the introduction of laser systems of control. An analysis and planning work in rice fields in the conditions of the Republic of Daghestan (RD). 

The work is devoted to experimental studies of the effect of the size of the faces of the cells of the honeycomb core on the carrying capacity of sandwich beams (TB). Experimental data allow us to determine the influence of the size of the faces of the cells of the honeycomb core on the carrying capacity of sandwich beams consisting of hexagonal honeycomb core and bearing layers United by the glue that is of interest engineering technicians and designers. 

The paper is devoted to the actual problem recycling crushing screenings brick battle and workmanship bricks using it as a fine aggregate in cellular foam concrete products.

The paper presents the analysis of the environmental situation of the region and the results of a study of waste crushing brick fight to improve the utilization of the product technology in cellular-concrete products. A comparative study of traditional cellular gas concretes and foam concretes and concretes based on recycled sand.

The paper discusses existing means for rectifying alternating electrical signal with inherent advantages and disadvantages. The proposed design of the AC voltage, made on the basis of the thermoelectric Converter using renewable solar energy. Made a rough calculation of this device. 

Suggested ways to improve the economic efficiency of investments in the construction of agro-industrial facilities in rural areas, allows them to increase the level of employment of the rural population, improving sew infrastructure economic activity in rural areas, to strengthen the management system of rural settlement and, most importantly, to improve the quality of life in rural areas. 

Motivated practicability shaping the portfolio investment, including securities highly profitable functioning and building hydroelectric station. It is offered situational managerial system by shaping the portfolio investment, which can provide necessary its structure in sloppy condition market. 

The paper presents the results of studies of production of the main products of the food and processing industry of the Republic of Daghestan, is considered the modern crisis of the industry and proposes measures of State support for the industry. 

It is considered complex organizing-technical action, which undertaking allows to raise the level intensive and extensive of the use in production process of the active part of the main fund and such way to enlarge the volumes of production. They are offered estimations to efficiency conducted action, which use allows to raise adequacy a result called on analysis and define the most effective actions, providing growing volume of production with minimum expenses.

It is stipulated that the construction company, chosen the strategy of economic growth, should have some competitive advantages, determining opportunities for sustainable development and effective improving, and operational efficiency increase. One of the factors of the competitiveness increase of construction products is the innovative potential of construction industry. Methodical approaches to the evaluation of innovative capacity and its effect on the growth of competitive advantages have been proposed. 

This article discusses the basic problems of management of institutions of health services in times of crisis, in the framework of the methodology for preventive diagnosis. Analyze the purpose and principles of preventive diagnosis techniques, providing a choice of adequate managerial influence on the institution of health services for the purpose of leveling the sources of origin of the crisis factors. The problem of diagnosis of the crisis of institutions of health services in the context of the management of the relations arising in the process of the formation mechanism of crisis management. A model of interaction elements of the mechanism of crisis management agencies of health services. 

The analysis of development of municipal and private partnership in regions of Russia is given, problems in development of municipal and private partnership in construction branch are revealed and the directions of increase of efficiency of municipal and private partnership in construction branch are defined. 

Our Authors.