Improving the thermal properties of the device in the process of forming a contact with the collector region of a silicon transistor
https://doi.org/10.21822/2073-6185-2022-49-3-6-13
Abstract
Objective. The objective of the study is to increase the reliability of the contact of the semiconductor transistor crystal to the body and the reproducibility of the technological process.
Method. A method for obtaining multilayer metallization of the reverse side of the crystal has been developed and the most optimal technological modes of its formation have been selected. The parameters of the reliability of the connection of the crystal to the body of the transistor were checked.
Results. Layer-by-layer metallization has been obtained, which provides a strong contact to the collector region of the transistor and a reliable fit of the crystal to the base of the case.The control of technological operations showed 100% distribution of solder over the surface of the crystal, the absence of pores in the solder, the improvement in the output characteristics of the device and the increase in the percentage of output usable transistors.
Conclusion. An analysis of the experimental results showed that in order to create a reliable contact and remove heat from the collector junction of power semiconductor transistors on the reverse side of the plates, it is necessary to form a metallization in one technological cycle, consisting of four layers of metals (Cr-Ni-Sn-Ag). The technical result of the research is to improve the quality of fit by obtaining a uniform distribution of the layer of Cr-Ni-Sn-Ag metals in a single technological cycle.
Keywords
metallization,
optimization,
solder,
semiconductor transistor,
crystal,
deposition,
contact,
collector,
reliability,
package
About the Authors
E. Kazalieva
Daghestan State Technical University
Russian Federation
Russian Federation
Post-graduate Student, Department of Theoretical and General Electrical Engineering
70 I. Shamil Ave., Makhachkala 367026, Russia
A. R. Shakhmaeva
Daghestan State Technical University
Russian Federation
Russian Federation
Cand.Sci. (Technical), Prof., Assoc.Prof., Department of Theoretical and General Electrical Engineering. Electrical Engineering
70 I. Shamil Ave., Makhachkala 367026, Russia
References
1. Anosov V.S., Gomzikov D.V., Ichetovkin M.I., Seydman L.A., Tychkin R.I. Issledovaniye protsessov izgotovleniya kremniyevykh kristallov tranzistorov v ikh korpuse. [Izvestiya vysshikh uchebnykh zavedeniy. Materialy elektronnoy tekhniki] News of higher educational institutions. Materials of electronic engineering.2017; 20(1): 51-59. (In Russ)
2. Anufriyev L.P., Yemel'yanov V.A., Kushner L.K. i dr. Povysheniye kachestva sborki integral'nykh skhem [Elektronnaya promyshlennost'] Electronics industry 1990; 5: 11-12. (In Russ)
3. Aronov B.Yu., Fedotov Ya.A. Testing and research of semiconductor devices. Proc. allowance for the specialties of semiconductor technology of universities. M.: Higher. School 1975; 325. (In Russ)
4. Gorlov M.I., Anufriev L.P., Bordyuzha O.L. ensuring and improving the reliability of semiconductor and integrated circuits in the process of serial production. Minsk: Integral Publishing House 1997; 390.
5. Gromov D.G., Mochalov A.I. Materials and processes of formation of metallization systems for silicon integrated circuits. Uch. allowance. M.: MIET 2006; 180. (In Russ)
6. Zenin V.V., Kolychev A.I., Mesheryakov M.V., Spiridonov B.A. Nickel coatings of traverses of housings for mounting electronic products. Physical metallurgy: Sat. scientific tr. Lipetsk: Izd-vo LEGI 2000; 111-117. (In Russ)
7. Zenin V.V., Segal Yu.E., Bokarev D.I. Soldering of crystals in power electronics products // Intelligent information systems: Abstracts. report scientific tech. Conf., June 23-25, 1999. Voronezh: VGTU Publishing House 1999; 221-222. (In Russ)
8. Ismailov T.A., Shakhmaeva A.R. Transistor structures of power electronics. St. Petersburg Polytechnic 2011; 125. (In Russ)
9. Ismailov T.A., Shakhmaeva A.R. Experimental study and optimization of the technological process of forming a contact to the collector region of silicon transistors. Basic processes for the formation of active regions of the structure of high-power silicon transistors. SPb.: Politekhnika 2009; 11. (In Russ)
10. Ismailov T.A., Shakhmaeva A.R., Yusufov Sh.A., Kazalieva E. //Method of forming a titanium-germanium contact layer for thermal stabilization of transistors. Herald of the Dagestan State Technical University. Technical Science. 2020; 47(4):49-56. DOI:10.21822/2073-6185-2020-47-4-49-56 (In Russ)
11. Kazalieva E. Metallization of the reverse side of the silicon wafer// Sat. works based on the materials of the IV International competition of scientific research works. Fundamental and applied aspects of the development of modern science. Ufa, 12. Kazalieva E. Planting transistor crystals on the base of the case. Sat. works based on the materials of the XXIX International Scientific Conference of Students, Postgraduates and Young Scientists "LOMONOSOV-2022". Moscow: Moscow State University, 2022. (In Russ)
12. Klimachev I.I., Litvinova T.V., Sidorenko S.I. Study of the stability of the Cr-Cu-Ni-Au system, with layers obtained by electrolytic deposition. Microelectronics. 1994; 23(2): 91-95. (In Russ)
13. Lashko S.V., Lashko N.F. Soldering of metals. 4th ed., revised. and additional M.: Mashinostroenie, 1988. (In Russ)
14. Patent of the Russian Federation No. 2375787. Method of planting a silicon crystal on the base of the housing / T.A. Ismailov, B.A. Shangereeva, A.R. Shakhmaev. Published on 10.12.2009. Bill. No. 34. (In Russ)
15. RF patent No. 2442243. Transistor based on a semiconductor compound / Erofeev E.V., Kagadey V.A., Anishchenko E.V., Arykov B.C., Ishutkin S.V., Nosaeva K.S. No. 2 010144198. Appl. 10/28/2010. Published 02/10/2012. (In Russ)
16. Segal Yu.E., Zenin VV, Fomenko Yu.L. Coatings of contact surfaces of crystals and IET cases. Petersburg Journal of Electronics. 2000; 1: 45-51. (In Russ)
17. Senko S.F., Belous A.I., Plebanovich V.I.A method of manufacturing a metallization system for silicon semiconductor devices. Patent for invention RU 2333568 C1, 10.09.2008. Application No. 200614979/28 dated 12/04/2006. (In Russ)
18. Chernyaev V.N. Technology for the production of integrated circuits and microprocessors: Textbook for universities. 2nd ed., revised. and additional M.: Radio and communication. 1987; 464. (In Russ)
19. Shakhmaeva A.R. Optimization of the technology of planting a silicon transistor crystal on the base of the case. Design and technology of electronic means. 2006; 4: 26-27. (In Russ)
20. Ivanova, Yu. A., Ivanou, D.K., Fedotov A.K. et al. Electrochemical deposition of Ni and Cu onto monocrystalline n-Si(100) wafers and into nanopores in Si/SiO2 template J. Mater. sci. 2007; 42:9163.
21. Pat. 3785892 US. Method of forming metallization backing for silicon wafer. Terry L.E., Wilson R.W. 1972.
Review
For citations:
Kazalieva E., Shakhmaeva A.R. Improving the thermal properties of the device in the process of forming a contact with the collector region of a silicon transistor. Herald of Dagestan State Technical University. Technical Sciences. 2022;49(3):6-13. (In Russ.) https://doi.org/10.21822/2073-6185-2022-49-3-6-13
Views:
279
Email this article 
