Calculation of the load-bearing capacity of the bent plates taking into account the diagrams of concrete deformation
https://doi.org/10.21822/2073-6185-2023-50-1-161-166
Abstract
Objective. The influence of the nature of the descending branch of concrete compression and stretching diagrams on the ultimate load-bearing capacity of bent cross-section reinforced concrete structures under various loading conditions close to destruction according to the nonlinear finite element model is investigated.
Method. The solution is performed by the finite element method in a physically nonlinear formulation using N.I.Karpenko's deformation theory. Deformation diagrams are used with different steepness of the descending branch. Calculations are performed by a step-by-step iterative method of successive loads on a layered model.
Result. The results of numerical calculation of slab reinforced concrete elements under various conditions of physical nonlinearity of concrete are presented.
Conclusion. The insignificant influence of the steepness of the descending branch on the load-bearing capacity of plate bendable structures has been found and the use of simplified diagram dependencies is fully justified for numerical calculations using a nonlinear model.
About the Authors
A. Y. Dzhankulaev
H.M. Berbekov Kabardino-Balkarian State University
Russian Federation
Russian Federation
Amerhan Y. Dzhankulaev, Cand. Sci. (Eng.), Assoc. Prof., Department of Building Structures and Mechanics
173 Chernyshevsky St., Nalchik 360004
O. M. Shogenov
H.M. Berbekov Kabardino-Balkarian State University
Russian Federation
Russian Federation
Oleg M. Shogenov, Cand. Sci. (Eng.), Assoc. Prof., Department of Building Structures and Mechanics
173 Chernyshevsky St., Nalchik 360004
Z. R. Likhov
H.M. Berbekov Kabardino-Balkarian State University
Russian Federation
Russian Federation
Zalimhan R. Likhov, Cand. Sci. (Eng.), Assoc. Prof., Department of Building Structures and Mechanics
173 Chernyshevsky St., Nalchik 360004
A. M. Kaziyev
H.M. Berbekov Kabardino-Balkarian State University
Russian Federation
Russian Federation
Aslan M. Kaziyev, Cand. Sci. (Eng.), Assoc. Prof., Department of Building Structures and Mechanics
173 Chernyshevsky St., Nalchik 360004
I. A. Blyanikhov
H.M. Berbekov Kabardino-Balkarian State University
Russian Federation
Russian Federation
Islam A. Blyanikhov, Master's student, Department of Building Structures and Mechanics
173 Chernyshevsky St., Nalchik 360004
References
1. Karpenko N.I., Mukhamediev T.A., Petrov A.N. Initial and transformed diagrams of concrete and reinforcement deformation. The stress-strain state of concrete and reinforced concrete structures.-M.:NIIZHB Gosstroy of the USSR, 1986;7-25. [In Russ]
2. Karpenko N.I. To improve the diagrams of concrete deformation to determine the moment of cracking and the breaking moment in bent reinforced concrete elements / N.I. Karpenko, O.V. Radaykin. Construction and reconstruction. 2010; 3 (41):10-16. [In Russ]
3. Karpenko N.I. To the definition of deformations of bent reinforced concrete elements using diagrams of concrete and reinforcement deformation. N.I. Karpenko, B.S. Sokolov, O.V. Radaykin. Theory of engineering structures. Building structures. 2012; 2 (40): 11-1911[In Russ]
4. Karpenko N.I. To the construction of methods for calculating core elements based on diagrams of deformation of materials [Text]N.I. Karpenko, T.A. Mukhamediev, M.A. Sapozhnikov. Improvement of methods for calculating statically indeterminate reinforced concrete structures. M.: 1987; 4-24.13[In Russ]
5. Karpenko N.I. On the construction of a generalized dependence for the concrete deformation diagram [Text] / N.I. Karpenko. Building structures. Minsk, 1983; 164-173.12[In Russ]
6. Karpenko N.I. To the calculation of strength, stiffness and crack resistance of non-centrally compressed reinforced concrete elements using a nonlinear deformation mode.N.I. Karpenko, B.S. Sokolov, O.V. Radaykin Izvestiya KGASU. 2013;4 (26): 113-120.25[In Russ]
7. Karpenko N.I. To the improvement of concrete deformation diagrams for determining the moment of cracking and breaking moment in bent reinforced concrete elements. N.I. Karpenko, O.V. Radaykin. Construction and reconstruction. 2010; 3 (41):10-16.15[In Russ]
8. Karpenko N.I. General models of reinforced concrete mechanics. M.: Stroyizdat, 1996;416[In Russ]
9. Karpenko S.N. On the construction of connections between stress and strain increments based on various diagrams [Text] Bulletin of Civil Engineers. SPbGASU. 2010;1.14[In Russ]
10. Dzhankulayev, A.Y., Likhov, Z.R., Shogenov, O.M. The Finite Element of the Plate with the Account of the Transformation of the Cross Section and the Nonlinear Foundation. Conference: 2018 IEEE International Conference "Quality Management, Transport and Information Security, Information Technologies" (IT&QM&IS). 2018; 8525048.
11. Dzhankulaev A.Y., Karpenko N.I. Methods of accounting for the volumetric stress-strain state in the calculations of reinforced concrete slabs. Materials of the 29th International Conference in the field of concrete and reinforced concrete. Moscow: Stroyizdat. 1992. [In Russ]
12. Dzhankulaev A.Y. Diagram of concrete deformation . Bulletin of the KBSU. Series of Technical Sciences. Issue 5.-Nalchik: Kab.-Balk. un-T., 2003;101-103. [In Russ]
13. Dzhankulaev A.Y. Modeling of the concrete deformation diagram in the MATLAB system. Gutov A.A., Kardanov M.M., Mashukov I.K., Kablo M.University Scientific Collection Nalchik: KBSU,2019;3[In Russ]
14. Finite element calculation model of the piled rafts. IOP Conference Series: Materials Science and Engineering 913(3),032054. Dzhankulayev, A.J., Guenko, N.A., Dzhankulayev, A.A., Dyshekov, H.M.
15. D.R. Mailyan., K.V. Kurgin. On the need to transform the basic analytical dependence "σb-eb" of concrete. Engineering Bulletin of the Don, 2011; 4.ivdon.ru/ru/magazine/archive / n4y2011/712. [In Russ]
16. Yeryshev V.A. Numerical methods for calculating the strength of reinforced concrete elements using a nonlinear deformation model using material deformation diagrams. Bulletin of the NGIEI. 2018;6 (85):17- 26.31[In Russ]
17. Z.R. Likhov, V.H. Khuranov, M.I. Bzhakhov, A.Ya. Dzhankulaev. Accounting of complete diagrams of deformation of materials in the calculation algorithm of bent reinforced concrete elements. Scientific and Technical Bulletin of the Volga region. Kazan. 2014;62:13-218. [In Russ]
18. Zenkevich O. Finite element method in engineering. M.: Mir, 1975; 542. [In Russ]
19. Bate K., R. Wilson. Numerical methods of analysis and the finite element method. M.: Stroyizdat, 1982; 448. [In Russ]
20. Nikulina Yu.A., S.I. Pirko, V.V. Kocherzhenko. Features of the application of nonlinear and simplified deformation calculation models for determining the strength of bent reinforced concrete elements of rectangular cross-section. Science and Innovation in Construction. 2017; 82-89[In Russ]
Review
For citations:
Dzhankulaev A.Y., Shogenov O.M., Likhov Z.R., Kaziyev A.M., Blyanikhov I.A. Calculation of the load-bearing capacity of the bent plates taking into account the diagrams of concrete deformation. Herald of Dagestan State Technical University. Technical Sciences. 2023;50(1):161-166. (In Russ.) https://doi.org/10.21822/2073-6185-2023-50-1-161-166
Views:
295
Email this article 
